Plastic Refinishing,
SXA 1043 Aerosol Flexible Sealer, PD-703
SXA 1043 Flexible Sealer was developed to provide a single component flexible
sealer. For use on repaired bumpers prior to using SX1044, priming or topcoating
flexible parts.
Features
- Single component, flexible
- Packaged in aerosol cans
- No additional flex additive needed
- Eliminates sand scratch swelling
Compatibles Surfaces
- Cured and sanded OEM finishes (except lacquer)
- Cured and sanded refinish topcoat systems
Related Products
- SX 1002 Sanding Paste
- SX 1004 Plastic Cleaner and Prep
- SX 1044 High Build Flexible Surfacer
Surface Preparation
- Apply SX 1002 Sanding Paste and abrade with a gray Scotchbrite pad, then
rinse thoroughly with water. Blow off surface.
- Clean with SX 1004 Plastic Cleaner and Prep.
- Sand with 400 grit sandpaper, blow off and re-clean with SX 1004.
Application Procedures
- Apply 1 -2 medium coats of SXA 1043 Flexible Sealer.
- Allow 30 minutes to dry.
- Apply 1 - 2 coats of SX1044 as needed
- Topcoat with appropriate PPG Topcoat System.
| Between
coats: |
5 - 10 minutes |
| Dust
Free: |
10 minutes |
| Air
Dry: |
Allow 30 minutes
drying time before priming |
| Fluid
Tip: |
1.3 - 1.5mm
or equivalent |
Attention:
When finished spraying aerosol products, hold can upside down and spray until
valve is cleared. This will prevent clogging of the internal valve.
Compatible Topcoats
- CONCEPT® (DCC) Acrylic Urethane
- CONCEPT® LV (CLV) Acrylic Urethane Color
- Delstar®, / Delthane® (DAR/ DXR80)
- Delstar® Acrylic Enamel
- Deltron® 2000 (DBC) Basecoat
- Deltron® (DBU) Universal Basecoat
- OmniT (MBC) Acrylic Basecoat
- OmniT(MTK) Acrylic Urethane
- OmniT (MLV) Low VOC Urethane
- OmniT" (MAE) Acrylic Enamel
- OmniT (MAE/MH) Acrylic Enamel
- OmniT(MCV) Acrylic Urethane
- OmniT (MCV) High Solids Urethane
- OmniT (MCV) Basecoat
- GLOBAL (BC) Basecoat Color
- GLOBAL (DG) Direct Gloss Color
- GLOBAL (DGLV) Direct Gloss LV Color
- Delta® 2800 (DHS) 2.8 VOC Polyurethane
- Delta® 3500 (DUHS) High Solids Polyurethane
- Delta® (DUHS) High Solids Polyurethane Basecoat
- Delta® (DFHS) Fast Dry High Solids Polyurethane
- Delta® (DGHS) Chemical Resistant Polyurethane
- Delta® (DSS) Medium Solids Polyurethane
- Delta® (DVHS) Fast Dry 2.8 VOC Polyurethane
Properties
| Packaged VOC (lbs./US Gal.) |
5.9 |
| Volume Solids (RTS) |
3.84 |
Sq. Ft. Coverage @ 1 mil
(100% transfer efficiency) |
61 |
